libvirt笔记 (4) —— log配置

Posted by nanxiao on 十一月 10, 2015 in libvirt笔记 |


The library configuration of logging is through 3 environment variables allowing to control the logging behaviour:

LIBVIRT_DEBUG: it can take the four following values:

1 or “debug”: asking the library to log every message emitted, though the filters can be used to avoid filling up the output

2 or “info”: log all non-debugging information

3 or “warn”: log warnings and errors, that’s the default value

4 or “error”: log only error messages

LIBVIRTLOGFILTERS: defines logging filters

LIBVIRTLOGOUTPUTS: defines logging outputs

Note that, for example, setting LIBVIRT_DEBUG= is the same as unset. If you specify an invalid value, it will be ignored with a warning. If you have an error in a filter or output string, some of the settings may be applied up to the point at which libvirt encountered the error.

libvirtd daemon程序也有三个类似的配置项(存储在配置文件libvirtd.conf):

log_level: accepts the following values:

4: only errors

3: warnings and errors

2: information, warnings and errors

1: debug and everything

log_filters: defines logging filters

log_outputs: defines logging outputs


When starting the libvirt daemon, any logging environment variable settings will override settings in the config file. Command line options take precedence over all. If no outputs are defined for libvirtd, it will try to use

0.10.0 or later: systemd journal, if /run/systemd/journal/socket exists 0.9.0 or later: file /var/log/libvirt/libvirtd.log if running as a daemon before 0.9.0: syslog if running as a daemon all versions: to stderr stream if running in the foreground

Logging in the library and the daemon




电子邮件地址不会被公开。 必填项已用*标注

Copyright © 2013-2017 我的站点 All rights reserved.
This site is using the Multi Child-Theme, v2.2, on top of
the Parent-Theme Desk Mess Mirrored, v2.5, from BuyNowShop.com